资阳摩托车科目四英文版

1. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

2. What is the meaning of this sign?

A. Sharp right curve

B. Bypass from right side

C. Continuous curves

D. Sharp left curve

Answer: A

3. What should motor vehicle drivers do when parking temporarily on a rainy day?

A. Turn on hazard lamp

B. Turn on front and back fog lamp

C. Turn on low-beam

D. Set up warning sign at the back of the vehicle

Answer: A

4. When rescuing the injured, it is necessary to ________.

A. Save life first and treat the wounds later

B. Treat the wounds first and safe life later

C. Help the slightly wounded persons first

D. Help the seriously wounded persons later

Answer: A

5. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

6. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

7. Which of the following is an inflammable solid material?

A. Matches

B. Fireworks

C. Calcium carbide

D. Explosives

Answer: A

8. When rescuing a wounded person in an emergency, it is necessary to firstly stop the bleeding by compression before other methods are taken according to the conditions of bleeding.

Answer: Y

9. When an erosive material catches fire, it should not be put out with water cannon.

Answer: Y

10. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

11. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

12. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

13. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

14. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C

15. Once inflammable gas causes a fire disaster, it should be put out with water in good time.

Answer: N

16. When a motor vehicle encounters a burning phenomenon, it should leave the vehicle quickly so as not to cause injury or asphyxia to the respiratory tract.

Answer: Y

17. What is the meaning of this sign?

A. No entry for bicycles

B. Lane for non-motorized vehicles

C. Special lane for bicycles

D. Bicycle stopping area

Answer: B

18. What is the meaning of this sign?

A. Reduce speed and go slowly

B. Watch for danger

C. Jammed section

D. Accident-prone section

Answer: B

19. What is the meaning of this sign?

A. Accident-prone section

B. Construction section

C. Reducing speed and going slowly section

D. Jammed section

Answer: A

20. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D