白城摩托车科四英文题

1. What is the meaning of this sign?

A. No U turn

B. No changing to left lane

C. No turning left

D. No entering the left lane

Answer: C

2. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A

3. What is the meaning of this sign?

A. No changing lane

B. No left turn

C. No going straight

D. No U turn

Answer: D

4. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

5. What is the meaning of this sign?

A. U turn

B. Reversing

C. Left turn

D. Bypassing

Answer: A

6. The first-aid measure to rescue a poisoned person is to _______.

A. Take warming-up measures

B. Bring him to a place where air is fresh

C. Give him artificial respiration

D. Depress the heart over the chest

Answer: B

7. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

8. When rescuing the persons who are losing blood, it is necessary to ______ first.

A. Observe

B. Dress the wounds

C. Stop bleeding

D. Inquire

Answer: C

9. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

10. When carrying the wounded persons in coma or in danger of suffocation, they should lie face up.

Answer: N

11. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

12. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

13. What is the meaning of this sign?

A. Crosswalk lights

B. Watch for pedestrians

C. Attention to traffic lights

D. Intersection

Answer: C

14. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and turn left

D. No going straight and no right turn

Answer: B

15. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C

16. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

17. The drivers, loaders and supercargoes responsible for dangerous chemicals transportation should all full understand the chemical characteristics, potential risks, features of the packaging containers and emergency measures for any unexpected accidents.

Answer: Y

18. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

19. What is the meaning of this sign?

A. Special lane for small vehicles

B. Special lane for motorized vehicles

C. Special lane for taxis

D. Special lane for multi-passenger vehicles

Answer: D

20. What needs attention when a motor vehicle drives on a road covered with ice and snow?

A. Braking length is extended

B. Anti-skating resistance will be greater

C. The adhesive force of the road will be greater

D. The braking length will be shorter

Answer: A